Htv printing8/13/2023 ![]() ![]() If you mainly cut polyurethane vinyl, the blades will last longer. The blade is worn: Blades wear and tear with every cut.But thicker vinyl or with a higher density requires a 60º blade, for example, flock HTV. You’re not using the right blade: Most HTV can be cut with a standard 45º blade.If it’s the first time you’re applying vinyl, you’ve selected the right cutting force, and the machine cannot cut it correctly, turn the flex sheet over because you might be cutting it on the wrong side. If you do it the other way around, you would be cutting the liner (which is thicker and rougher) and not your HTV. The sheet must be placed face up in order to cut the vinyl. The vinyl hasn’t been inserted correctly into the machine: most HTV sheets have their liners facing outwards.If your vinyl cutter has problems cutting it, it may be that: Heat transfer vinyl is usually very thin, smooth and easy to cut. These creases can usually be removed by ironing. Wrinkles may appear on fine HTV when applied to cotton and washed in hot water. Some HTV can withstand high temperatures, but it’s always best to wash them in cold water. Garments customised using HTV must be washed as delicate garments, inside out and in cold water. Another factor to consider is washing conditions.For elastic fabrics, you should use a special HTV. For example, if you’re using general HTV onto elastic fabrics. The same problem can occur if you’re not using the right HTV for the type of fabric you're personalising.If you’re combining HTV with a metallic effect with another vinyl, you must place the HTV with a metallic effect on top. If the vinyl you’re using requires to be hot peeled, you can combine it with other HTV with the same requirements. When applying several layers, you should use HTV with similar characteristics.When the vinyl sticks initially but falls off afterwards, the problem is usually caused by incorrect application of several HTV layers or incorrect washing of the garment. Sometimes, you can remove this coating, but in other cases, we will have to accept that the surface can’t be customised using HTV. The water-repellent coating is usually found on tents or nylon rain jackets. The presence of a coating on the fabric could also be the reason why vinyl doesn’t stick to the garment is the presence of a coating on the fabric, generally water-repellent or antimicrobial products.If the HTV doesn’t stick to the garment, increase the pressure of your heat press. You should check the product’s datasheet and follow the instructions. Depending on the vinyl, you will need to apply more or less pressure. The heat press works by adjusting the time, temperature, and pressure. ![]() Instead, we should increase the pressure. We usually adjust the time and temperature correctly but increase the pressing time if the HTV doesn’t stick. This usually happens due to a lack of pressure at the time of pressing. Sometimes, after pressing the vinyl, the letters or the design that has just been transferred to the garment will come off when removing the liner. This can happen at the beginning of the application process or afterwards. One of the most common problems is that heat transfer vinyl can come off the garment where it’s supposed to stick. Why isn’t my HTV sticking to the fabric?. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |